If you experience these problems, contact your local field rep or corporate support for a replacement SAR. If a change occurs on a non-interrupt Port B pin 86 to ns before a Port B interrupt on change occurs, the interrupt may not happen. Subsequent captures will occur properly. Contact your local field rep or corporate support for a replacement SAR. The pins function when the program is running.
This is an emulator-only issue. In order to emulate these devices, Microchip provides a two-part solution. Then attach a modified test clip to this part. Solder the rfPIC12Fx-ds to the target. Attach the test clip onto the chip to be emulated. It is recommended that all pins except those listed in the table in step f be isolated from the target chip. Attach the device adapter to the processor module.
Insert the eight-lead pin header that came with the device adapter into the device adapter. Attach leads from the pin header to the test clip in the following order: Pin Connections:. Apply power to the devices. Emulation Technology, Inc. Microchip Technology Inc. Note: If you have accidentally installed the Windows OS default driver, the following instructions will direct you to how to "clean" your system first before installing the correct driver s.
When a stack full condition is met, a warning box if enabled will pop up, informing the user that a stack full has occurred.
This behavior follows the device spec sheet. Likewise with the stack underflow, a warning box if enabled will pop up, informing the user that a stack underflow has occurred. Known problems that remain may be fixed or are retained to highlight the issues. The following is a list of known problems. Otherwise registers will unnecessarily be reserved for debugging. Follow the instructions on your screen to find the advanced or communications settings. In order to emulate these devices, Microchip provides a two-part solution.
Then attach a modified test clip to this part. Solder the rfPIC12Fx-ds to the target. Attach the test clip onto the chip to be emulated.
It is recommended that all pins except those listed in the table in step f be isolated from the target chip. Attach the device adapter to the processor module. Insert the eight-lead pin header that came with the device adapter into the device adapter.
0コメント